Penetrating waterproofing Teknomer 100 is an effective solution for protecting concrete from water and moisture. Water destroys concrete even when it is not noticeable. Basements, wells, swimming pools, dams, water mains, tunnels, infrastructure structures are objects where it is important to make proper waterproofing.
Teknomer 100 is a penetrating waterproofing for concrete based on special cements and active additives. It penetrates deep into the pores of the concrete and blocks them from water and moisture penetration forever.
Key advantage: Teknomer 100 withstands positive and negative water pressure (up to 7 Bar). That is, this waterproofing works even when water presses on the concrete from the outside. That is why Teknomer 100 is chosen for complex and responsible objects.
The material is used for:
— waterproofing of basements and cellars
— wells made of reinforced concrete rings
— swimming pools and drinking water tanks
— tunnels, elevator shafts, subways
— water pipelines, dams and infrastructure structures
— and also for capillary cutoff before brickwork.
How to use penetrating waterproofing correctly
To prepare the working solution, you need 6–7 liters of clean water per 20 kilograms of dry Teknomer 100 mix. Knead for 5 minutes until smooth, then leave the mixture to stand for 3 minutes. Mix the solution thoroughly again for 2 minutes immediately before application. Applying Teknomer 100 penetrating waterproofing Before applying Teknomer 100 penetrating waterproofing, it is important to moisten the surface well. Teknomer 100 can be applied with a brush or by spraying in 2-3 layers. Each subsequent layer of waterproofing is applied perpendicular to the previous one.
