How to securely glue a granite slab or monument: the best epoxy adhesive for stone TEKNOBOND 400

If you are looking for a strong and durable adhesive for granite, marble, concrete or metal, pay attention to the two-component epoxy adhesive TEKNOBOND 400. In this article, we will look at its main advantages, application methods and important nuances of work that will help you get the perfect result.

 

Which glue is best for bonding granite?
When choosing a glue for bonding granite, marble, natural and artificial stone, it is important to consider its strength, adhesion and resistance to external factors. TEKNOBOND 400 is an ideal construction glue because it provides:

  • High adhesion – reliable adhesion to granite, concrete, metal, tiles, glass and wood.
  • Excellent strength – withstands loads up to 60 MPa in compression.
  • Ease of application – the thixotropic formula allows the glue to be used even on vertical surfaces.
  • Water and chemical resistance – provides durability and protection against moisture.
  • Easy to work with – mixes and applies without shrinkage, which guarantees a high-quality result.

 

How to properly glue a granite slab or monument?
1. Surface preparation

  • Clean the granite slab or stone from dust, grease and dirt.
  • For better adhesion, use a wire brush or degreaser.

2. Glue preparation

  • Open both TEKNOBOND 400 components (A and B).
  • Mix each thoroughly separately, then mix together in the correct proportion.
  • Use a low-speed mixer (350-400 rpm) or a spatula to manually mix small amounts of glue.
  • You need to mix until you get a homogeneous creamy consistency.

3. Applying glue

  • Spread the glue in an even layer of 2-12 mm on both surfaces to be glued.
  • Press the granite pieces together tightly and level them.
  • Remove excess glue before it hardens.

4. Drying time

  • The glue starts to set quite quickly, so you should work quickly.
  • Full bond strength is achieved after 24-48 hours.

 

Where else can TEKNOBOND 400 be used?

  • Repair of cracks and chips in concrete
  • Installation and bonding of granite, marble, glass, wood, stone
  • Fixing metal to concrete
  • Anchoring of reinforcing bars
  • Seam sealing in combination with Teknomer tape

Adhesive for concrete, marble, granite TEKNOBOND 400 is:

  • Reliability and durability – ensures a strong connection even in difficult conditions.
  • Resistance to moisture and aggressive environments – not afraid of water and chemical exposure.
  • Easy preparation and application – no special skills required.

 

If you need a reliable adhesive for bonding granite, concrete, natural stone, TEKNOBOND 400 will be the perfect choice. A detailed video review of the material follows:

 

 


For additional information and the correct selection of material, call: +38 (067) 486 42 41