|
Quantity
|
Total
|
||
|
|
|||
Granito Diamond is a cement-based finishing material containing special chemical additives. The material is used to create a decorative coating on walls and floors inside premises and on facade walls.
Areas of application
- For walls inside and outside the premises
- For indoor floors
- Applied to concrete, plastered cement and gypsum surfaces, painted surfaces, drywall, provided they are primed beforehand
- For bathrooms, kitchens and shower rooms, provided they are varnished
Features and benefits
- Creates a continuous coating
- Has a flexible structure
- Can be applied over existing coatings
- Can be colored
- Vapor permeable, but does not let moisture in from the outside
Instructions for use
Before applying the material, the surface should be cleaned of any oil, rust, detergents, dirt and other substances that prevent setting, and also clean the surface of old and swollen layers of paint, if any. Old synthetic-based surfaces should be carefully sanded and the surface should be cleaned of dust.
If there are cracks or cavities on the surface, they should be filled with Teknorep repair mixtures.
Mix
To prepare the working solution, pour 4.5-5.5 liters of water into a clean container and pour out the dry powder, if necessary, add a special dye. Using a mixer at low speed, knead the mixture until a homogeneous mass without lumps is obtained. The amount of water for mixing may vary depending on the ambient temperature. Leave the resulting mixture for 1 - 2 minutes, then mix again.
Causing
The finished working solution is applied to the previously prepared surface with a metal spatula in 2 or 3 layers. The time interval between the application of each subsequent layer should be 3-4 hours. The total thickness of the applied layer should be 2-4 mm.
Polishing and the necessary structure of the pattern are performed with a metal spatula when applying the last layer of Granito Diamond.
If necessary, sand the surface 24 hours after applying the last layer of Granito Diamond.
Wax or varnish should be applied to the surface no earlier than 48 hours after the last layer of Granito Diamond has been applied.
Cleaning the tool
Tools and equipment used must be washed with water immediately after use. Once the material has cured, cleaning of the tool will only be possible mechanically.
Technical information
| Color | White, Gray |
| Material base | Cement |
| Application thickness | 2-4 mm (in 2-3 layers) |
| Application temperature | (+5°C) - (+35°C) |
| Drying time |
Sanding - after 24 hours Time to complete drying - 48 hours At low air temperatures and high humidity, working and drying times may increase. |
Material consumption |
1.5 kg/m² |
| Pot life of the finished solution | 30 minutes |
| Operating temperature | (-30°C) - (+80°C) |
| Tensile strength | 1.5 N/mm² (after 28 days) |
| Compressive strength |
7 N/mm² (after 7 days) 20 N/mm² (after 28 days) |
| Tensile strength |
4 N/mm² (after 7 days) 8 N/mm² (after 28 days) |
| Capillary water absorption | Class W2 (0.2 kg/m² × min ⁰י⁵) |
| Vapor permeability coefficient | 5/20 (tabular value) |
| Thermal conductivity | ≤ 0.42 (tabular value) P = 50% |
| Fire resistance | Class A1 |