Epoxy self-leveling floor Teknobond 500 two-component 20kg. (Ral 7040)

Teknobond 500 is a two-component epoxy self-leveling floor.

Areas of application:

• For medium-duty areas such as repair shops, loading docks
• For warehouses
• For multi-storey and underground parking lots
• For residential premises, cafes, restaurants and educational institutions
• For hangars and wet production facilities for the production of beverages and food products

Features and benefits:

• Resistant to chemicals: acids, alkalis and detergents
• Wearproof
• Does not change its properties in a humid environment and with temperature changes
• It has no joints, which prevents aggressive substances from entering the concrete and destroying it.
• Waterproof, so no additional waterproofing is required
• Easy to use
• Has a wide color palette
• Forms a beautiful glossy surface
• It is possible to create a matte or semi-matte finish

Instructions for use:

• Before application, clean the surface of any type of oil, rust, detergents, dirt and other substances that prevent setting.
• The recommended compressive strength should be from 25 N/mm2, and the tensile strength from 1.5 N/mm2.
• To prepare the working mixture, component B should be added to component A and mixed with a mixer for 2 - 3 minutes at low speed (400 rpm) until a homogeneous mixture is obtained.
• Before using Teknobond 500, Teknobond 300 primer should be applied to the surface.
• Teknobond 500 should be applied with a notched trowel.

Notes on application/restrictions:

• It is not recommended to leave the material in direct sunlight after application, the surface may burn out.
• When using the material at high air temperatures, it dries faster, and at cold temperatures, it dries longer.
• The product may cause irritation if it comes into contact with the skin. Work clothes, protective gloves, a mask and goggles must be worn. Before starting work, you can apply a protective cream to your hands. In case of contact with eyes, rinse immediately with warm water and consult a doctor.
• When storing Teknobond 500 at temperatures below 0°C, the material may crystallize.
• After applying the material, it is necessary to protect the surface from adverse weather conditions, such as direct sunlight, strong wind, high air temperature (over +35°C), rain and frost.
• Used tools and equipment should be washed with warm water immediately after use.
• Before application, clean the surface of any type of oil, rust, detergents, dirt and other substances that prevent setting.
• The recommended compressive strength should be from 25 N/mm2, and the tensile strength from 1.5 N/mm2.
• To prepare the working mixture, the component should be added to component A and mixed with a mixer for 2 - 3 minutes at low speed (400 rpm) until a homogeneous mixture is obtained.
• Before using Teknobond 500, Teknobond 300 primer should be applied to the surface.
• Teknobond 500 should be applied with a notched trowel. 

FEATURES