Teknodeko decorative plaster (Bark beetle, 2 mm) 25 kg

Teknodeko Cizgili is a one-component, moisture-resistant, white decorative plaster on a cement base, reinforced with polymers, for external and internal finishing.

Application areas:

• For decorative coating of concrete surfaces
• For decorative coating of external thermal insulation systems of facades
• For work on any mineral surfaces
• For internal and external use
• For work on horizontal, vertical and overhead surfaces
• For residential premises, shopping centers, hospitals

Properties of decorative plaster:

• Easy to use
• Possibility of obtaining different designs
• It has high resistance to any climatic conditions.
• Moisture resistant
• Prevents accumulation of excess moisture
• Corrects surface defects
• Long lasting
• Non-flammable
• Steam permeable
• Can you apply paint over plaster?

Instructions:

• Before applying the material, clean the surface from any type of oil, rust, detergents, dirt and other substances that prevent adhesion.
• If there are cracks or cavities on the surface, they must be sealed using Teknorep cement mixtures .
• Before laying, the surface should be slightly moistened.
• Pour 5.5-6.0 liters of clean cold water into a clean container. Slowly pour the Teknodeko dry mix (25 kg) into the container with water and use a low-speed mixer to mix the composition for at least 10 minutes until a homogeneous mass is obtained. Leave the resulting mixture for 5 minutes, then mix again.
• For each new batch of mixture, you should use the same amount of water. Otherwise, you may get a different shade.
• The prepared mixture should be used within 2 hours, depending on weather conditions.
• The mixture should be applied evenly to the surface with a steel spatula, scraping off excess material from the surface to obtain a layer of the required thickness. After which, within 5-10 minutes, a pattern should be made.
• The design is applied using circular movements with a plastic or polyurethane spatula.
• The material should be applied continuously until it reaches the butt ends or corners of the surface.

Notes:

• Do not add hardened material to water.
• The surface should be coated in 2 layers to increase resistance to external influences and contamination, as well as to prevent the coating from having different shades.
• The consumption of plaster depends on the pattern.
• Work should be carried out at an air temperature of +5 to +35 °C. When plastering at low (below +5 °C) or high (above +35 °C) temperatures, it is necessary to cover the surface with heat-insulating material.
• The product may cause irritation if it comes into contact with the skin. It is necessary to use work clothes, protective gloves, a mask and glasses. You can also apply a protective cream to your hands before starting work. In case of contact with eyes, rinse eyes immediately with warm water and consult a doctor.
• After applying the mixture, it is necessary to protect the surface from adverse weather conditions, such as direct sunlight, strong wind, high air temperature (over +35 °C), rain and frost.
• The surface can be painted, but not earlier than 7 days after the plaster has been applied. When applying dark paints, it is necessary to use a paint primer.
• The instruments and equipment used must be washed with warm water immediately after use.

Characteristic