Transparent polyurethane-based waterproofing, UV-resistant Teknobond 660, 5 kg.

Teknobond 660 — transparent two-component waterproofing material based on polyurethane, resistant to ultraviolet rays.

Areas of application 

• Waterproofing of balconies and terraces.
• Waterproofing of glass brick walls.
• Waterproofing and preservation of natural stone.
• Waterproofing and wood protection.
• Waterproofing of metal surfaces.
• Use on surfaces that require resistance to ultraviolet radiation.

Features and benefits

•  Has excellent adhesion to surfaces such as concrete, stone, ceramics, asphalt, steel, wood.
• Can be applied with a brush, roller or sprayer.
• Resistance to ultraviolet radiation, heat resistance, resistance to abrasion, impact and chemicals.
• Easy to apply to horizontal and vertical surfaces.

Application information
Surface quality: the surface must be free from any dust, dirt, loose and volatile particles, cement mortar residues and oils. The concrete surface must have sufficient compressive strength (at least 25 N/mm2), the tensile strength must be at least 1.5 N/mm2.

Notes/Limitations

• Do not use at the minimum permissible temperature until the material has completely hardened. 
• The product may irritate the skin. Protective gloves and goggles must be worn. Protective hand cream can be applied before starting work. If the solution gets into the eyes, rinse them immediately with water and consult a doctor.
• If the material is stored at temperatures below 0°C for a long time, crystallization may occur in the product. If the crystals dissolve by returning the product to room temperature, it can be used again.
• After adding component B, mix component A for 2-3 minutes until a uniform color is obtained using a low-speed mixer (up to 400 rpm).
• Contact with skin may cause irritation. Avoid contact with eyes.
• Equipment used must be cleaned immediately after application. Cured product can only be cleaned mechanically.