Paint for asphalt and concrete based on synthetic resin and solvent Teknobond 960, 25 kg (Gray color) RAL 7001

Teknobond 960  is a “cold” road paint for asphalt and concrete based on synthetic resin and solvent.
Areas of application: 

• Highways, motorways, public roads
• Airports, bridges
• Residential buildings, shopping malls, municipal buildings
• Sidewalks, curbs, paving stones
• Used on asphalt and concrete in all types of engineering structures

Paint properties:

• Suitable for "cold" application
• Quick-drying, even when applied in a thick layer
• Wear-resistant
• Resistant to ultraviolet radiation
• The color of the paint does not change regardless of the surface of application
• Reflective

INSTRUCTIONS FOR USE

• Before applying the material, clean the surface from any types of oil, rust, detergents, dirt and other substances that prevent setting. Recommended tensile strength - from 1.5 N/mm ² . 
• If there are cracks or potholes on the concrete or asphalt surface, they should be repaired first.
• Before applying the material, clean the surface from any types of oil, rust, detergents, dirt and other substances that prevent setting. Recommended tensile strength - from 1.5 N/mm ² .
• If there are cracks or potholes on the concrete or asphalt surface, they should be repaired first.
• The paint is applied in one layer, but if it is necessary to apply the material in 2 layers - the second should be applied after 1 hour. It is applied with a brush, roller or a special device for marking road paint.
• If necessary, the paint can be diluted with Tekno thinner in an amount of 5-8% by volume/weight of the paint and applied using a mechanical sprayer. It is necessary to wait 15 minutes between coats.

Notes:

• Paint should never enter sewers or drains.
• After partial use, the paint container must be tightly closed.
• Do not apply paint during rain.
• Do not dilute paint with water.
• After applying the paint, the surface should be protected from adverse weather conditions, such as direct sunlight, strong wind, high air temperatures (above +35 °C), rain and frost.
• Tools and equipment used must be cleaned immediately after use.

FEATURES