WG 145 wall guardrail with handrail function, white, 4 linear meters.

The WG145 handrail bumper is a wall-mounted bumper for wall protection. This model is the best option for medical centers and hospitals, as it has two functions - a handrail and a bumper. It has an impressive appearance due to the complete set, both external and internal transition elements, which allows you to mount the bumper around the perimeter of the room with a single strip, and this is an excellent design and functional solution.

WG145 is a 145mm wide and 85mm deep wall bumper that combines wall protection with the convenience of support . The sturdy , solid aluminum profile is securely attached to the wall using brackets at 60-75cm intervals .

Vinyl coating with rubber shock-absorbing gasket effectively softens impacts and prevents damage to the finish. Decorative end elements add aesthetics and allow the system to harmoniously fit into a modern interior.

The bumper is supplied in 4-meter-long profiles. The antibacterial, hygienic coating is free of heavy metals, making the WG145 ideal for hospitals, clinics, nursing homes, educational and community facilities.

- Protects walls from impacts
- Convenient handrail function
- Aesthetic design and wide choice of colors
- Safe for rooms with increased hygiene requirements

Bumper characteristics

Base: aluminum profile

Profile length:  4 m

Height: 145 mm

This bumper is sold with additional plugs, external and internal corners, and accessories.

Installation of the rammer:

• Before installation, it is necessary to measure the required length of the aluminum supporting profile, then cut off the required length.
• Mark and drill holes for installation in the aluminum supporting profile, with a diameter of 6-6.5 mm. The guardrails are attached with the following types of dowels, which are not included in the delivery set:

brick base, dowel 10x60 (80), self-tapping screws 6x160;

concrete base, 10x60 dowel, 6x160 screws; 

plasterboard base, Molly dowel, 6x140 bolts.

• The next step is to drill holes in the wall using a punch (at the rate of 2 brackets per 1 m2, but no more than 600 mm between brackets). For marking, use an aluminum support with already prepared mounting holes as a template.
• Complete the installation of the supporting aluminum profile by alternately placing the brackets opposite the holes and securing them without tightening them with self-tapping screws or bolts to the corresponding dowel.
• Cut the required length of the internal shock absorber and fix it in a special groove located in the aluminum supporting profile.
• The final fixation of the aluminum supporting profile with self-tapping screws (bolts) is carried out after installing all transitional and finishing elements (plugs, corners).
• Installation of all transition and finishing elements (plugs, corners) to the aluminum supporting profile is carried out using self-drilling screws 3.9x16 DIN 7504 N.
• After performing all of the above steps, it is necessary to finally fix the aluminum profile with self-tapping screws (bolts) to the base of the wall, having previously placed it in the installation position.
• Cut to size and install decorative vinyl overlays and polycarbonate panels.
• For straight sections longer than 4 m/s, the installation of the aluminum supporting profile and vinyl decorative lining must be done butt-to-butt and with a minimum gap of 100 mm.