Chemical anchor moisture-resistant, fast-hardening Teknobond 401 W (410 ml).

Teknobond 401 W is a moisture-resistant, thixotropic, quick-drying chemical anchor based on synthetic epoxy acrylate resin.

Fields of application:

• For installation of fittings and connecting rods in concrete, hollow and solid brick
• For anchor bolts and pins
• For installation of pipes and plumbing in central heating, ventilation, etc.
• For fixing injection packers
• For gluing all types of building materials

Chemical anchor properties:

• Quick-hardening
• Easy to use
• Pasty
• Does not slide off any type of surface
• Prevents the process of corrosion of fittings
• It has high resistance to chemicals
• It is easily applied even on wet surfaces

Instruction:

• Before applying the material, clean the surface of any types of oil, rust, detergents, dirt and other substances that prevent sticking, using compressed air.
• Concrete bases must be clean, strong and have sufficient adhesion.
• Work should be carried out at ambient and surface temperatures from + 5 °C to + 35 °C.
• Using a perforator, drill a hole of the required diameter and depth. The diameter and depth of the hole must correspond to the size of the anchor element used. The hole should be cleaned of dust and dirt with a round wire brush and compressed air. Next, the trigger should be squeezed and held until the two separate components of the cartridge come together from the tip of the static mixer. Slowly pull the cartridge out, filling the hole and making sure there are no air gaps inside.
• In deep holes, you can use an extension cord. When inserting the anchor, it is necessary to rotate it. Next, you should place the anchor element in the hole. During curing, the anchor element cannot be moved or loaded.
• To open the cartridge cover, rotate it. Then install the static mixer tip. Place the cartridge in the gun and start applying.
• When stopping the application process, the tip of the static mixer can be left on the cartridge after the pressure is released.
• If the resin has hardened in the static mixer, a new insert must be installed before starting work.

Notes:

• Use anchor dowels to fix anchor material to hollow materials (bricks or blocks).
• When storing an open cartridge, remove the static mixer, wipe the neck of the cartridge with a clean dry cloth and close the lid.
• Contains styrene.
• Combustible.
• Harmful by inhalation
• The product may cause irritation if it gets on the skin or in the eyes. It is necessary to use work clothes, protective gloves, a mask and glasses. In case of contact with the eyes, immediately wash the eyes with warm water and consult a doctor.
• Store in a place inaccessible to children
• Use in well-ventilated areas
• The tools and equipment used must be cleaned immediately after use.

Characteristics