Hybrid polymer one-component waterproofing Teknomer 700, 1.5 kg.

Product description

A single-component, modified with new generation hybrid resins, ready-to-use waterproofing material that retains its permanent elastic structure, can be applied to wet surfaces, is resistant to ultraviolet light, and does not contain isocyanates or solvents.

Areas of application

• On terraces, roofs, balconies and facades.
• When repairing cracks and sealing seams.
• On foundations and retaining walls.
• On cracks on the surface of thermal insulation.
• To protect concrete structures from water and corrosion.
• On the facades of buildings.
• For waterproofing under ceramic tiles.
• For application to wooden and metal surfaces.

Features and benefits

• It has the property of bridging cracks.
• Resistant to ultraviolet light.
• Provides excellent adhesion even to wet surfaces.
• Maintains elasticity even at low temperatures.
• Easy to apply (with a roller or brush).
• Does not require prior priming of the application surface.
• Has excellent adhesion even to difficult surfaces.
• Creates a seamless layer of waterproofing.
• Resistant to non-pressure and pressure water pressure.
• It has high frost resistance.

Instructions for use

Surfaces must be clean, flat, sound, free from any dust, grease, dirt, rust, formwork grease, detergents and other similar substances and residues that prevent adhesion. If there is delamination (segregation) in the concrete, damaged and loose parts must be removed and weak parts must be eliminated. If there are cracks or cavities in the floor or wall to be coated, they must be repaired with appropriate TEKNOREP repair solutions.

TEKNOMER 700 can be applied to the surface with a brush or roller. TEKNOMER 700 is a ready-to-use product. It should be applied evenly using a special roller (short-haired roller). It is recommended to apply in one layer of the desired thickness. In case of application in 2 layers, do not wait for the first layer to dry completely (check by the “peel-off” method). If desired, a fiberglass mesh can be used as a reinforcing material between the layers of TEKNOMER 700.

After application, the surface should be protected from adverse weather conditions such as direct sunlight, strong wind, high air temperatures (above +35°C), rain and frost. Before the product has completely hardened, hands should be cleaned with water and detergent. Tools should be cleaned of the material immediately after completion of work. After the product has hardened, it can only be cleaned mechanically.

Application Notes / Limitations

• When applying in two layers, pay attention to the drying of the first layer "to the point of peeling". Do not apply in the rain.
• Do not apply to bitumen-based coatings.
• No, dilute with water, do not add foreign substances.
• Freshly applied material should be protected from weather conditions such as rain, etc., until fully cured.

FEATURES