Universal concrete additive, adhesion primer Teknolatex 500, 10 kg.

Teknolatex 500 –It is a universal concrete additive that provides waterproofing properties and increases adhesion, is used as a primer and as an additive for plaster, self-leveling mixtures, etc. It improves the resistance of concrete to moisture, aggressive substances and abrasion, and also provides elasticity and prevents cracking.

APPLICATION

• As an adhesion additive in solutions for repairing damaged concrete surfaces.

• As a primer before applying self-leveling mortars, screeds, plasters, adhesives.

• As a waterproofing additive to plaster mortars.

• As an additive to screeds to protect against cracking and dust formation.

• To improve the adhesion of finishing materials to the substrate.

FEATURES / ADVANTAGES

• Provides excellent adhesion between old and new concrete surfaces.

• Reduces the absorption capacity of porous surfaces.

• Provides elasticity and plasticity of mortars.

• Makes surfaces resistant to chlorine, oils and salts.

• Minimizes the likelihood of cracking.

• Ensures water resistance of the surface.

• Suitable for indoor and outdoor use

INSTRUCTIONS FOR USE

SUBSTRATE QUALITY / PREPARATION

Before applying the material, the surface must be cleaned of any oil, rust, dust, hardened binder and paint residues, mold, concrete care products, other surface treatment substances that may interfere with adhesion. If there are cracks, voids or depressions on the surface, they must be repaired (filled) using the appropriate Teknorep or Teknogrout repair solutions.

Teknolatex 500 is a ready-to-use emulsion. Mix thoroughly for 3 minutes before use.

APPLICATION

To increase adhesion and water resistance of concrete and plaster mortars

Teknolatex 500 is added and mixed in a ratio of 1:1 to 1:4 to the amount of water (reducing the amount of water by the same proportion) directly into the concrete mixer before adding cement, sand and other components of the mixture. To increase the plasticity of the solution, if necessary, the superplasticizer Teknoflow Super can be added to the solution (in the amount specified in the technological card).

To increase the adhesion of old concrete to new concrete or to use as a base coat before plastering

Used to prevent cold joints on new concrete or to apply screed to old concrete and to increase adhesion.

Mixing proportions of the working solution:

A: 1 kg of cement, 3 kg of washed quartz sand (fraction 0-3 mm)

A: 1 kg of Teknolatex 500 to 2 kg of water.

The components are mixed until a homogeneous working solution is formed.

The working solution is applied to a previously moistened surface until matte with a layer 2 mm thick. Application of plaster, screed or new concrete must be carried out within 20 minutes, until the adhesive layer dries.

To reduce water absorption of absorbent surfaces

Teknolatex 500 can be used as a primer for absorbent surfaces in its pure form or diluted with clean water. It must be applied with a roller or brush.

CLEANING THE TOOL

Tools and equipment must be rinsed with water immediately after completion of work. After hardening, it can only be removed from the surface mechanically.

MATERIAL DATA BASIS

The above technical data are obtained from laboratory tests carried out at a temperature of + 20 °C and a relative humidity of 50% in the Tekno Yapı Kimyasalları laboratory. The results are obtained 28 days after the tests. The actual characteristics of the material may vary due to reasons beyond our control.

RESTRICTIONS/PRECAUTIONARY MEASURES

Teknolatex 500 may cause skin irritation. When using the material, cover exposed areas of the body and wear safety glasses. If the emulsion gets into the eyes, immediately rinse the affected areas with plenty of running water and consult a doctor.

TECHNICAL INFORMATION

APPLICATION INFORMATION